Product Support Page

S&X Commercial Anti-Slip Tape with 60-Grit High Traction

Reliable traction. Commercial-grade durability.

Engineered for commercial environments — workshops, equipment areas, stairs, ramps, and walkways. The 60-grit aggressive surface paired with wear-resistant multi-layer construction delivers heavy-duty grip for demanding applications.

Backed by S&X's 25+ years of coated-abrasives expertise, every roll is engineered for reliable, long-lasting performance you can trust.

Rolls: 1"-24" × 60 ftPre-Cut: 6" × 24" / 30"Indoor & Outdoor

Watch Installation Video

Get it right the first time — under 2 minutes

Watch Before Installation

Why watch before you install?

Ensure proper installation for maximum safety
Get the best performance and long-lasting results
Avoid common mistakes and save time

Install in 4 Simple Steps

1

Clean & Prep

Wipe with isopropyl alcohol. Surface must be clean, dry, and free of dust or grease.

2

Spot Test

Test on an inconspicuous area first to confirm surface compatibility.

3

Measure & Cut

Cut to length with sharp scissors. Round the corners to prevent edge lifting.

4

Apply & Bond

Peel the release film and apply. Place the film over the grit, then press firmly with a scraper. Allow 24h to cure.

Important Precautions

Temp Control: Apply only when surface is at least 10°C (50°F). Pre-warm if cold.
Surfaces: Avoid raw wood, porous concrete, or submerged areas. Prime/seal first.
Removal: Heat with a hair dryer, then peel slowly to minimize adhesive residue.

Surface Guide

Recommended Surfaces

Concrete

Metal

Tile

Sealed Wood

Glass

Fiber Cement

Avoid or Prepare First

Dusty Surface

Oily Surface

Wet Surface

Peeling Paint

Loose Coating

Cracked Surface

Why It Works

Heavy-Duty Grip

60-grit aggressive surface delivers heavy-duty traction for commercial use.

Multi-Layer Build

Wear-resistant multi-layer construction handles scuffs, abrasion, and high-traffic areas.

Long-Lasting Durability

Built tough for workshops, equipment areas, and busy commercial environments.

Weatherproof

Stands up to rain, washdowns, and outdoor conditions year-round.

Care & Maintenance

Clean regularly with mild soap and water.
Avoid harsh chemicals and solvents.
Inspect periodically and replace if worn.
Keep the surface clean and dry.

Safe Removal

Warm the tape with a heat gun or hair dryer.
Peel back slowly at a low angle.
Remove any residue with adhesive remover.
Test on a small area first.

Frequently Asked Questions

1.What surfaces does it work on?

Concrete, metal, tile, sealed wood, glass, and fiber cement work best. See the Surface Guide above for details.

2.Can it be used outdoors?

Yes. The wear-resistant construction and weatherproof adhesive make S610 suitable for outdoor stairs, ramps, and walkways.

3.How long will it last?

Lifespan depends on traffic and conditions, typically 12-24 months in normal commercial use. Inspect periodically and replace when worn.

4.Can it get wet?

Yes, the tape is water-resistant once installed. Make sure the surface is fully dry before applying.

5.How do I remove the tape?

Warm with a hair dryer, peel slowly at a low angle, then clean any residue with adhesive remover.

6.How is S610 different from S810 (Premium) and other S&X series?

S610 is our commercial-grade workhorse — 60-grit aggressive surface with wear-resistant multi-layer construction, designed for workshops, equipment areas, and busy walkways. S810 (Premium) upgrades to 80-grit ultra-traction with reinforced base for the most demanding applications. For specialty needs, see S610R (reflective), S690 (glow-in-the-dark), or S680 (heavy-duty hazard warning).